GRAUPNER mc-16 Programming Manual page 70

B asi c s ett ing s
Own
Stick mode
M o dula tio n
DSC Output
It should be noted here once again that, in the interest
of greatest flexibility in combination with the prevention
of unintentional operating errors, no controls are preas-
signed to control channels 5 ... 8 respectively 5 ... 12
by default.
This means that, in the system's delivered
state, only servos attached to receiver
outputs 1 ... 4 can typically be operated by
the two sticks and that any servos attached to
receiver connectors 5 ... max. 12 will remain in
their middle positions.
Firmware version V1102 and lower
A newly initialized helicopter model is also able to
more-or-less move servo 6 – depending on the position
of the right-side proportional rotary slider, which is the
default throttle limiter control.
Firmware version V1103 and higher
A newly initialized helicopter model is also able to
more-or-less move servo 6.
With either model type, this situation will only change
after appropriate assignments have been made in the
»Control adjust« menu.
On the other hand, if a newly initialized model memory
is to be put into operation then it MUST first be appro-
priately "connected" with one or more receivers before
the servos attached to the receiver/s can be operated.
More about this can be found in the section "Binding"
on page 80 or 90.
70 Program description - Loading a new memory location
A fundamental description of programming steps for
a winged aircraft model can be found in the program-
ming examples section beginning on 280, or for heli-
1
copter models beginning on page 320.
Ho TT
The menu descriptions below are arranged in the se-
PPM10
quence individual menus are listed in the multi-function
SEL
list. However, since the
HoTT transmitter types covered by this manual differ
in their software structure as well as their hardware
features, these instructions always indicate the "soft"
differences between the individual transmitter types
at the start of a menu description, as they are in the
Contents. The key is as follows:
Key:
16
20


mc-16 HoTT and mc-20
mc
16 20
 
applicable to HoTT
mc-16
applicable to mc-20 HoTT
standard option
option is unavailable