GRAUPNER mc-16 Programming Manual page 225

You will then have to re-establish a connection be-
tween the teacher and pupil transmitters.
mc-16 Firmware up to V 1.002
mc-20 Firmware up to V 1.019
If, on the other hand, the selection keys on the left or
right four-way button are used to select "INH" ...
Please select
Trainer link?
ACT INH
... and this selection is confi rmed by tapping the centre
SET key of the right four-way button, then the existing
teacher connection is restored. The same approach is
used if the transmitter is confi gured as a pupil transmit-
ter.
mc-16 Firmware V 1.003 or higher
mc-20 Firmware V 1.020 or higher
If, on the other hand, the selection keys on the left or
right four-way button are used to select "INH" ...
Please select
Trainer link?
ACT INH
... and this selection is confi rmed by tapping the centre
SET key of the right four-way button, then the existing
teacher connection is restored. Then you will reset the
transmitter in question back to its "normal" operating
mode.
For immediate resumption of "normal" model opera-
tion, then switch to the line "RF module" of the menu
"Basic adjustment model", page 84 and 94, and
put this in the corresponding value fi eld back to "ON".
Alternatively, turn off for a few seconds from the trans-
mitter and confi rm the appearing after restarting the
transmitter query ...
P l e a s e s e l e c t
R F o n / o f f ?
O N O F F
... by briefl y pressing the central SET
four-way button.
Binding to a teacher or pupil transmitter must then be
made if necessary again.
key of the right
Program description - Teacher/pupil 225