GRAUPNER mc-16 Programming Manual page 114

In5 GL fr –––
In6 GL ––– 3
In7 GL fr –––
In8 GL fr –––
nor mal
typ
Now put the 3-way switch back into its middle posi-
tion. Move the marker frame as necessary to the left
into the column labelled with the new switch symbol,
briefly tap on the centre key of the right four-way
SET
button then assign the switch's other switch direction
by once again starting from the middle position but this
time move the switch in the other direction.
The display will now present the given switch number
together with a symbol indicating the given switch
direction, for example:
In5 GL fr –––
In6 GL 2 3
In7 GL fr –––
In8 GL fr –––
normal
typ
Tips:
• When assigning switches, pay attention to
the desired switching direction and also
that all unused inputs remain "free" or are
again reset to "free". This is necessary to ensure
that inadvertent actuations of these unused con-
trols cannot cause malfunctions.
• The travel setting described below allows the ap-
propriate end state to be established for an as-
signed switch.
114 Program description - Control adjust | Winged models
Erasing a transmitter control or switch assignment
0%
A simultaneous tap on the  or  keys of the right
0%
four-way button (CLEAR) while on an input line with
0%
an active transmitter control or switch assignment – see
0%
above figures – will reset the given input back to "fr" and
"---".
offset
Column 4, "offset"
The control centre for the given control, i. e. its zero
point, can be changed in this column. The adjustment
range lies between -125 % and +125 %.
In5
In6
In7
In8
nor mal
0%
A simultaneous tap on the  or  keys of the right
0%
four-way button (CLEAR) will reset the entry field value
0%
displayed in inverse video back to "0 %".
0%
Column 5, "– travel +"
The "-Travel+" column is accessed by using the Select
offset
button  of the left or right-hand four-way button to
shift the marker frame to the right, beyond the "Offset"
column, as indicated by the right-pointing arrow at bot-
tom left of the screen.
This column is used to set servo travel symmetrically
or asymmetrically for each side. The setting range is
±125 % of normal servo travel.
Select an input, 5 through 8 or 5 through 12, with the
 selection keys of the left or right four-way button.
GL fr ––– 0%
GL 2 3 0%
GL fr ––– 0%
GL fr ––– 0%
typ offset
To set symmetric travel, i. e. control-side independent
travel, the respective operating element (transmitter
control or switch) is to be put into a position in which
the travel setting will be covered on both sides by the
marker frame:
In5 +100% +100%
In6 +100% +100%
In7 +100% +100%
In8 +100% +100%
nor mal
– travel +
To set asymmetric travel, the respective operating
element (transmitter control or switch) is to be moved
to the side to be set such that the marker frame only
includes the value to be changed:
In5 +100% +100%
In6 +100% +100%
In7 +100% +100%
In8 +100% +100%
nor mal
– travel +
The value setting is activated by briefly touching the
centre SET key of the right four-way button. The value
field/s will be displayed in inverse video. Values can be
changed with the selection keys of the right four-way
button:
In5 +100% +100%
In6 +111% +111%
In7 +100% +100%
In8 +100% +100%
nor mal
– travel +