GRAUPNER mc-16 Programming Manual page 243

RX FREE MIXER
RX FREE MIXERV3.78
MIXER : 1
MASTER CH: 00
SLAVE CH : 00
S–TRAVEL–: 100
S–TRAVEL+: 100
RX WING MIXER
TAIL TYPE: NORMAL
Value Explanation Possible settings
Vx.xx Receiver's None
firmware version
MIXER Mixer selection 1 ... 5
MASTER CH Signal source or 0, 1 ... depending
source channel on receiver
SLAVE CH Target channel 0, 1 ... depending
on receiver
S-TRAVEL– Admixing to the 0 ... 100 %
"-" side of servo
travel in% servo
S-TRAVEL+ Admixing to the 0 ... 100 %
"+" side of servo
travel in% servo
RX WING tail type NORMAL,
MIXER V-TAIL, ELEVON
TAIL TYPE (vertical/horizontal
mixer for delta and
flying wing)
MIXER
Up to five mixers can be programmed simultaneously.
Use "MIXER" to switch between mixers 1 ... 5.
The following settings in this display always for just the
mixer selected in the "MIXER" line.
Important notice:
If you have already programmed mixer
functions in the »Wing mixer« or »Free
mixer« menus, make absolutely sure that
these mixers do not overlap with those in the
menu "RX FREE MIXER"!
MASTER CH ("from")
According to the same principles described in the
section "Free mixer" on page 200, the signal applied
at the MASTER CH (signal source or source channel)
is mixed to a variable extent to the SLAVE CH (target
channel).
Select "00" if no mixer should be set.
SLAVE CH ("to")
The signal of the MASTER CH (source channel) is
mixed proportionally to the SLAVE CH (target channel).
The mix ratio will be determined by the percen tages
entered in the lines "TRAVEL–" and "TRA VEL+".
Select "00" if no mixer should be set.
TRAVEL–/+ (proportion of the admix in %)
With the settings of these two lines the percentage of
the admix is specified in relation to the MASTER signal
separately for each direction.
RX WING MIXER TAIL TYPE (tail unit type)
The following model types are also available in the
"Tail" line of the »Model type« menu, on page 98
and should, preferentially, be preset there. In this case,
always leave the TAIL TYPE set to NORMAL.
However, if you would prefer to use the mixer inte-
grated in the receiver, you can select the already pre-
adjusted mixer functions for the corresponding model
type:
• NORMAL
This setting corresponds to the classic aircraft type
with rear tail unit and separate rudder and elevator.
No mixer function is necessary for this model type.
• V-TAIL (V-tail unit)
With this model type the elevator and rudder control
functions are connected, so that each of the two
tail unit flaps – each controlled with a separate ser-
vo – assume both the elevator and rudder function.
The servos are normally connected to the recei ver
as follows:
OUTPUT CH 3: Left V-tail servo
OUTPUT CH 4: Right V-tail servo
If the servo's direction of rotation is incorrect, please
observe the notices on page 65.
• ELEVON (delta/flying wing models)
The servos connect at the outputs 2 and 3 assume
the aileron and elevator function. The servos are
normally connected to the receiver as follows:
OUTPUT CH 2: Left horizontal/vertical
OUTPUT CH 3: Right horizontal/vertical
If the servo's direction of rotation is incorrect, please
observe the notices on page 65.
Program description - Telemetry 243