GRAUPNER mc-16 Programming Manual page 261
Hide thumbs
Also See for mc-16:
- Programming manual (104 pages) ,
- Programming handbook (10 pages) ,
- Operating instructions manual (49 pages)
Table of Contents
Advertisement
Column, "Output"
The three ring limiters are pre-assigned to receiver
outputs 3/4, 9/10 and 11/12 by default, whereby the
outputs in column "X" are for the forward/reverse func-
tion and the outputs in column "Y" are for the left/right
function. However, this preset combination of receiver
outputs can be replaced as necessary by any other
combination at any time. This is essentially done in the
same manner as described previously under "Input",
for example:
Ring limiter
4
3
4
3
OFF
3
10
9
4
OFF
4
3
6
7
OFF
X
Y
X
Y
Input
Output
SET
Note:
Watch out for undesirable overlaps if you use
one of the outputs within a mixer.
Column, "SET"
The SET column is used to determine just which of the
ring limiters is to be "OFF" and which are to be "ON",
i. e. active. Use the selection keys on the left or right
four-way button to move the marker frame to the de-
sired value field in the SET column then briefly tap the
centre SET key of the right four-way button:
Ring limiter
4
3
4
3
OFF
4
3
10
9
OFF
4
3
6
7
OFF
X
Y
X
Y
Input
Output
SET
In the value field now displayed in inverse video, make
a choice between the two options, "ON" and "OFF",
with the or selection keys then conclude the
entry with a brief tap on the centre
ESC
four-way button or on the centre
SET
four-way button.
A tap on the or keys of the right four-way
button at the same time (CLEAR) will reset the active
value field back to its "OFF" default value.
"Settings page"
Ring limiter
4
3
4
3
ON
4
3
10
9
ON
4
3
6
7
ON
X
Y
X
Y
Input
Output
SET
Following a selection of one of the three lines with the
selection keys, switch to the settings page for the se-
lected ring limiter (1 ... 3) with a brief tap on the centre
SET
key of the right four-way button:
R.
lim.
1
CH 4
CH 3
100% 100%
0%
0%
max-X
If, however, the small diamond at the centre of the
circle in the figure above (which represents the current
stick position) is not visible ...
R.
CH 4 CH 3
100% 100%
key of the left
0%
key of the right
max-X
... then the respective ring limiter is still switched
"OFF". In this case, switch back to the previous page
with a brief tap on the centre
way button then switch the respective ring limiter "ON"
as previously described.
Programming procedure
The two upper value fields – labelled at the bottom left
of the display as "max-X" or "max-Y", depending on
the position of the marker frame – are used to specify
separate settings for each of the two control functions,
"left/right" and "forward/reverse" within a range of 25
...
R.
CH 4 CH 3
25%
0%
max-X
... and 125 %:
R.
CH 4 CH 3
125%
0%
max-X
In practice, the setting is made by changing the given
value until the respective servos in the model just reach
the point where they no longer move.
Program description - Ring limiter
lim.
1
0%
ESC
key of the left four-
lim.
1
100%
0%
lim.
1
100%
0%
261
Advertisement
Table of Contents
