Using The Cross Tube With Back Guide - Otto Bock DISCOVERY TMAX Instructions For Use Manual

Usage
The seating systems can be removed or attached to the trapezoid adapter in just a few steps.
Removing the seating system
1) Stand next to the seating unit and hold it by the backrest with one hand.
2) Pull the release button on the lower section down (see Fig. 33, item 1). The locking bolt will release the
adapter.
3) At the same time, slide the seating unit forwards and remove it (see Fig. 33, item 2).
→ The seat has been removed.
Mounting the seating system
1) Place the seating unit (see Fig. 34, item 3) on the lower section. Slide the upper section (see Fig. 34, item 1)
from the front onto the lower section (see Fig. 34, item 4).
2) Slide the seating unit backwards until the locking bolt on the lower section audibly engages.
Visually check that it has locked correctly.
3) Make sure the seating unit is secure by giving it a few short tugs and sliding it forwards.
→ The seat is installed.
32
34

6.3.1.5 Using the Cross Tube with Back Guide

The cross tube with back guide for seating shell backs allows the angle of the seating shell backrest to be adjusted
independently.
1) Release the clamping lever (see Fig. 35).
2) Twist the back guide on to the cross tube (see Fig. 36).
3) Close the clamping lever tightly (see Fig. 35).
22 | Ottobock
33
discovery tmax