Otto Bock DISCOVERY TMAX Instructions For Use Manual page 14

Preparation for Use
INFORMATION
For disassembly/transportation see the section "Disassembly/Transportation".
A few simple steps are sufficient for preparing the wheelchair for use:
1) For plug-on rear wheels: slide the rear wheels onto the wheel attachments of the wheel adapters (see Fig. 58,
see Fig. 59). The quick-release axles must not be able to be removed after the pushbutton has been released.
2) Slide the footrests into the holders on the front frame tube (see Page 25).
3) Insert the anti-tipper in the active position (anti-tipper rollers facing down):
→ Push in the rear locking pin (see Fig. 5).
→ Insert the anti-tipper (see Fig. 6).
→ Release the locking pin. The front locking pin must engage audibly. Visually check that the pin is engaged.
→ For activating/deactivating the anti-tipper see Page 31.
4) Mount the seating shell/seating system:
→ Ottobock Shape System: mounted prior to delivery by the qualified personnel that adapted the wheelchair.
→ Seat board: the seat cushion is secured against sliding by pushing it onto the hook-and-loop closures.
→ Seating systems from other manufacturers: mounted according to the individual specifications of the qualified
personnel.
WARNING
Improper adaptation of third-party seating systems
Risk of falling, tipping over, serious injuries
► The safe adaptation of a third-party seating system is the sole responsibility of the qualified personnel provid­
ing the fitting. The qualified personnel must complete these tasks according to the manufacturer's specifica­
tions. Ottobock assumes no liability in case of problems with third-party seating systems.
3
5
14 | Ottobock
4
6
discovery tmax