Throttle Lever; Engine Start/Stop Button; Variable Trim System (Vts) Button (If So Equipped) - Sea-doo GTX 4-TEC Operator's Manual

TYPICAL
1. Adjustment knob

3) Throttle Lever

When the throttle lever is pushed, the
watercraft accelerates. When fully
released, engine automatically slows
down to idle speed and watercraft is
gradually stopped by water drag.
4) Engine Start/Stop
Button
To start engine, depress and hold the
start/stop button. Release immedi-
ately after engine is started.
To stop engine, depress the start/stop
button. When stopped, disconnect
safety lanyard from the post. It is
suggested to release throttle lever
first.
WARNING
Directional control
when the throttle is released or
when engine is off.
______________________
38
is reduced
smo2006-002-001_a

1. Engine start/stop button

5) Variable Trim
System (VTS) Button
(if so equipped)
Located just
start/stop button, this button is used
to change pump jet nozzle position
and to adjust ride to suit watercraft
load and water conditions.
smo2006-002-020_a
TYPICAL
1. VTS button
A VTS position indicator is included in
the information center gauge. See IN-
FORMATION CENTER in this section.
below the engine