Engine Cut-Off Switch; Throttle Lever; Ibr Lever (Intelligent Brake And Reverse) - Sea-doo SAR 2018 Series Operator's Manual

NOTE: If the START/STOP button is
pressed and held without the tether
cord installed, the information cen-
ter displays will stay on as long as the
START/STOP button is held.

3) Engine Cut-Off Switch

The engine cut-off switch is located in
the middle of the handlebar.
smo2011-003-018_b
TYPICAL
1. Engine cut-off switch
To allow engine starting, the tether
cord cap must be securely snapped
onto the engine cut-off switch.
WARNING
Always attach the tether cord clip
to the operator's personal flota-
tion device (PFD) or wrist (wrist
strap required).
smo2014-008-002_a
TYPICAL
1. Tether cord cap on the engine cut-off switch
2. Tether cord clip secured to operator's PFD
To stop engine, pull the tether cord cap
from the engine cut-off switch.
Should the engine be stopped, the
brake function (models with iBR)
and watercraft directional control
is lost.
Always disconnect the tether cord
when the watercraft is not in oper-
ation in order to prevent accidental
engine starting or to avoid unau-
thorized use by others, children,
and to prevent theft.

4) Throttle Lever

The throttle lever on the RH handle-
bar electronically controls the engine
speed.
To increase or maintain watercraft
speed, pull on the throttle lever with
your finger.
To decrease watercraft speed, release
the throttle lever.
smo2009-002-201_a
TYPICAL
1. Throttle lever
2. To accelerate
3. To decelerate
The throttle lever is spring loaded and
should return to rest position (idle)
when not pressed.
5) iBR Lever (intelligent
Brake and Reverse)
The iBR lever on the LH handlebar can
electronically command:
– Reverse
_______________
CONTROLS
WARNING
WARNING
41