Sea-doo GTX 4-TEC Operator's Manual page 43

WARNING
Never use the depth gauge as a
warning device to ride in shallow
water. Use it as a navigation guide
only. Not to be used for navigation
purposes.
NOTE: Water temperature and depth
gauge will be displayed alternately.
All Models
Hourmeter (HR)
Displays the time in hours of the wa-
tercraft usage.
Message Display
Displays a message whenever one of
the following circumstances occurs.
The abbreviations between parenthe-
sis here are the code displayed:
– engine or exhaust system overheat-
ing (EXHAUST or ENGINE)
– low oil pressure (OIL)
– low battery voltage (12 V LOW)
– high battery voltage (12 V HI)
– low fuel level (FUEL-LO)
– maintenance reminder (MAINT)
NOTE: When the watercraft is due for
a maintenance inspection, the mes-
sage MAINT will blink. After servic-
ing, your authorized Sea-Doo dealer
will clear it.
– check engine (CHK ENG)
NOTE: If a fault occurs, this sys-
tem generates numbered fault codes
(P-XXXX) that are displayed through
the information center. In case of a
failure, you may call your authorized
Sea-Doo dealer and he would be able
to assist you to obtain the code de-
scriptions to help troubleshooting.
– sensor failure (vehicle electronic
equipment) (SENSOR)
– invalid safety lanyard (KEY)
– safety lanyard, learning key active
(L KEY)
A beeper will sound and indicator light
will blinks depending on the fault oc-
curring to catch the driver attention
when necessary.
Except for low liquid levels, which can
be corrected by refilling, it is recom-
mended to see an authorized Sea-Doo
dealer when other messages occur.
5) Indicator Lights
NOTE: Refer to INFORMATION DIS-
PLAY above for additional information
regarding messages.
Low oil pressure (OIL)
Check engine (CHK ENG)
Engine or exhaust system
overheating (H-TEMP)
Low fuel level (FUEL-LOW)
Low/high battery voltage
(12 V LOW/HI)
Maintenance reminder (MAINT)
_____________________
41