Flushing Connector - Sea-doo GTX 4-TEC Operator's Manual

TYPICAL
1. Boarding step
Pull down the step with your hand and
hold until a foot or a knee is put on the
step.

27) Flushing Connector

A convenient connector is provided
to allow easy installation of a garden
hose to flush the exhaust cooling sys-
tem.
WARNING
When operating the engine while
the watercraft is out of the water,
the heat exchanger in the ride plate
may become very hot. Avoid any
contact with ride plate as burns
may occur.
______________________
50
ALL MODELS EXCEPT RXP
RXP MODELS
1. Flushing connector
On some models, an additional flush-
ing connector is located in engine
compartment to allow flushing while
watercraft is on a lift or if you prefer to
flush from this location, either flush-
ing connector can be used to flush
the exhaust cooling system. Remove
seat to gain access.