Maintenance; Lubrication - Sea-doo GTX 4-TEC Operator's Manual

MAINTENANCE

WARNING
Only perform procedures as de-
tailed in this guide. It is recom-
mended that the assistance of
an authorized Sea-Doo dealer be
periodically obtained on other
components/systems not covered
in this guide. Unless otherwise
specified, engine must not be run-
ning and the safety lanyard must
be removed from its post for all
maintenance procedures.
er use jet pump components or
side vanes to lift the watercraft.
Certain components in the engine
compartment may be very hot.
Direct contact may result in skin
burn. When operating the engine
while the watercraft is out of the
water, the heat exchanger in the
ride plate may become very hot.
Avoid any contact with ride plate
as burns may occur.

Lubrication

Anticorrosion Protection
Throttle Cable
Lubricate the throttle cable with XP-S
LUBE or equivalent.
Throttle Body
Lubricate throttle body with XP-S
LUBE or an equivalent.
Models Equipped with
Lubrication Fitting
Use fitting for that purpose provided in
the engine compartment.
Make sure to spray lubricant at least 3
to 5 seconds for proper lubrication.
______________________
94
smo2006-002-026_a
Nev-
GTI MODELS — TYPICAL
1. Fitting
smo2006-002-025_a
OTHER MODELS — ENGINE COVER
1. Fitting
Models Without Lubrication
Fitting
Remove the air intake hose from throt-
tle body.