Throttle Lever; Ibr Lever (Intelligent Brake And Reverse) (All Models Except Gts); Mode/Set Buttons (All Models Except Gts) - Sea-doo GTS Series Operator's Manual

how to operate the watercraft while
gaining the necessary confidence and
control.
The learning and rental modes also
offer the possibility of setting the ma-
ximum speed of the watercraft.
OPERATING MODES
Refer to
tion for details.

4) Throttle Lever

The throttle lever on the RH handle-
bar electronically controls the engine
speed.
To increase or maintain watercraft
speed, pull on the throttle lever with
your finger.
To decrease watercraft speed, release
the throttle lever.
smo2009-002-201_a
TYPICAL
1. Throttle lever
2. To accelerate
3. To decelerate
The throttle lever is spring loaded and
should return to rest position (idle)
when not pressed.
5) iBR Lever (intelligent
Brake and Reverse) (All
Models Except GTS)
The iBR lever on the LH handlebar can
electronically command:
– Reverse
– Neutral
– Braking.
NOTE: A minimum of 25% lever travel
is required to activate iBR functions.
subsec-
smo2011-003-020_a
TYPICAL - iBR LEVER
1. iBR lever
2. Lever rest position
3. 25% stroke required to activate iBR function
4. Operating range
At speeds below 14 km/h (9 MPH),
pulling the iBR lever in will engage re-
verse.
NOTE: If water current is 14 km/h
(9 MPH) or above, the reverse can not
be engaged as the speed threshold for
the reverse is exceeded.
At speeds above 14 km/h (9 MPH),
pulling the iBR lever in will engage the
brake.
When the iBR lever is released after
braking or reverse operation, neutral is
engaged.
If the throttle lever is still pulled in
when releasing the iBR lever, for-
ward movement will be initiated
after a short delay. If forward ac-
celeration is not desired, release
the throttle lever.
NOTE: The neutral position can be fine
tuned by trimming the iBR system.
Refer to
subsection for detailed instructions.
6) MODE/SET Buttons (All
These buttons are located on the RH
side of the handlebar.
Press MODE button to scroll through
various functions available through the
information center.
_______________
WARNING
OPERATING INSTRUCTIONS
Models Except GTS)
CONTROLS
47