Throttle Cable Inspection - Sea-doo GTX 4-TEC Operator's Manual

TYPICAL
1. Air intake hose
2. Throttle body
Open the throttle body valve by press-
ing slightly the throttle lever.
Spray XP-S LUBE lubricant through the
throttle body bore to lubricate valve
mechanism.
TYPICAL
1. Open throttle body valve
2. Lubricate valve mechanism
Reinstall air intake hose.
Electrical Connections
As necessary,
product such as dielectric grease on
battery posts and all exposed cable
connectors.
CAUTION: Do not lubricate connec-
tors of the Multi-Purpose Electron-
ic Module (MPEM) and the engine
Electronic Control Module (ECM).
apply anticorrosion
Additional Lubrication
XP-S LUBE or equivalent will help pre-
vent corrosion of metallic parts and
maintain proper operation of moving
mechanisms.
Do not lubricate the safety lanyard
post.
Ski/Wakeboard Post (if so equipped)
Lubricate ski/wakeboard post through
all its length. Pull out then push in sev-
eral times to distribute the lubricant.
Reverse Gate
Lubricate pivoting points and mecha-
nism.

Throttle Cable Inspection

Throttle Cable
Depress and release the throttle lever.
It should operate smoothly and return
to its initial position without any hesi-
tation. There must be a small amount
of free-play when throttle lever is re-
leased. Refer to an authorized Sea-
Doo dealer if necessary.
CAUTION: Never attempt to adjust
the idle speed through the throttle
body tamper proof screw. If so, it
would impair the idle speed stabil-
ity. Besides, no adjustment could
be performed by the dealer nor the
factory to correct the idle speed.
The throttle body would need to
be replaced at the customer's ex-
pense. Also take into account that
might change the engine emission
level and the engine might not meet
the EPA/CARB requirements.
Do not alter or tamper with throttle
cable adjustment or routing.
_____________________
WARNING
WARNING
95