Safety Lanyard And Engine Start/Stop Button; Water Flow In Exhaust Manifold; To Freezing Point) - Sea-doo GTX 4-TEC Operator's Manual

Safety Lanyard and
Engine Start/Stop Button
Position shift lever in neutral. Ensure
that both switches operate properly.
Start engine and stop it using each
switch individually.
WARNING
Should the safety lanyard cap is
loose or fail to remain on its post,
replace it immediately in order to
avoid unsafe use.
Water Flow in Exhaust
Manifold (only when
temperature is below or
close to freezing point)
In Northern areas, if watercraft is to
be used when temperature is below or
close to freezing point (0°C (32°F)) or if
watercraft was left unused while tem-
perature was below or close to freez-
ing point, water may be frozen in the
supply hose going to the exhaust man-
ifold. This could cause exhaust cool-
ing system overheating. To ensure it
is properly working, do the following
prior to using the watercraft:
– The procedure is to be performed
with watercraft out of water.
– Connect a garden hose to the flush-
ing connector at jet pump.
– Perform the flushing operation as
explained in
CARE.
– Ensure water flows out of jet pump.
Otherwise, water is frozen in sup-
ply hose and restricts water flow.
Do not operate the watercraft in
this condition.
NOTE: Pay attention that some water
will also flow out of exhaust outlet.
Make sure water is effectively flowing
out of jet pump.
Operating
CAUTION:
with frozen water in supply hose
might lead to engine components
damage.
______________________
68
POST-OPERATION
watercraft
NOTE: When water freezes, no dam-
age to engine components will occur
as water expands but it may cause
damage by preventing full flow of cool-
ing water.
– Either wait until ice melt or pour
some hot water on supply hose go-
ing to exhaust manifold. Then, per-
form the flushing operation again
to make sure water properly flows
out of jet pump. If you need assis-
tance, refer to an authorized Sea-
Doo dealer.
WARNING
Do not use any electrical heating
device to heat the hose. Electrical
devices may generate sparks that
would ignite fuel vapors that might
be present in the bilge causing a
fire or an explosion.
– Ensure to drain bilge if water is
present.