Fuse Identification - Sea-doo GTX 4-TEC Operator's Manual

All Models
Fuses rating are identified, look beside the fuse holders.

Fuse Identification

Camshaft position sensor 10A
Spare fuse (accessory),
Depth sounder (GTX LTD)
Cylinder 3 ignition coil
and injection
Spare fuse (permanent
12V)
Cylinder 2 ignition coil
and injection
Cylinder 1 ignition coil
and injection
Squeeze locking tabs together, hold
and pull fuse cover from the MPEM.
TYPICAL
1. MPEM
2. Fuse cover
Use the tabs of the fuse cover to re-
move and reinstall fuses. Slide cover
tabs along fuse top.
2A
10A
1A
10A
10A
_____________________
MPEM
1. Fuse cover
2. Fuse tabs
One cover contains spare fuses.
To gain access to spare fuses, remove
the cover identified "SPARE FUSES IN-
SIDE". Look inside cover and pull the
rubber protector with a finger. Take
care not to drop the fuses.
3A Bilge pump (optional), beeper,
diagnostic connector
5A Information center gauge,
TOPS sensor
10A Electric starter, fuel pump
2A MPEM
7.5A VTS (if so equipped)
5A EMS, start/stop switch
99