Bandwidth Control - TP-Link TL-WR843N User Manual

Chapter 5
• Destination Network
to which the static route is assigned.
• Subnet Mask - The Subnet Mask determines which portion of an IP address is the
network portion, and which portion is the host portion.
• Gateway - This is the IP address of the gateway device that allows contact between
the router and the network or host.
• Interface - This interface tells you whether the Destination IP Address is on the LAN &
WLAN (internal wired and wireless networks), or the WAN(Internet).
• Click Refresh to refresh the data displayed.

5. 13. Bandwidth Control

5. 13. 1. Control Settings
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to Bandwidth Control
The values you configure for the Egress Bandwidth and Ingress Bandwidth should be
less than 100,000Kbps. For optimal control of the bandwidth, please select the right
Line Type and consult your ISP for the total egress and ingress bandwidth.
• Enable Bandwidth Control
can take effect.
• Line Type - Select the right type for you network connection. If you are not sure,
please consult your ISP.
• Egress Bandwidth - The upload speed through the INTERNET port.
• Ingress Bandwidth
5. 13. 2. Rules List
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
- The Destination Network is the address of the network or host
> Control Settings.
- Check this box so that the Bandwidth Control settings
- The download speed through the INTERNET port.
Configure the Router in Standard Wireless Router Mode
107