Removing A 1.8-Inch Ssd From A 1.8-Inch Ssd Carrier - Dell PowerEdge M830 Owner's Manual

1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #1 screwdriver ready.
3. Remove the 2.5-inch hard drive or SSD from the 2.5-inch hard drive or SSD carrier.
Steps
1. Slide the hard drive or SSD into the hard drive or SSD carrier.
2. Align the screw holes on the hard drive or SSD with the holes on the hard drive or SSD carrier.
CAUTION: To avoid damaging the drive or the carrier, do not overtighten the screws.
3. Fasten the four screws to secure the hard drive or SSD to the hard-drive or SSD carrier.
Figure 49. Installing a 2.5-inch hard drive or SSD in a 2.5-inch hard-drive or SSD carrier
1. screw (4)
3. hard drive or SSD carrier
Next steps
Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing a 2.5-inch hard drive or SSD from a 2.5-inch hard drive or SSD carrier
After working inside your system

Removing a 1.8-inch SSD from a 1.8-inch SSD carrier

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
116
2. hard drive or SSD
4. screw hole (4)