Dell PowerEdge M830 Owner's Manual page 42

Option Description
Dell Controlled Controls the turbo engagement. Enable this option only when System Profile is set
Turbo to Performance.
Number of Cores Controls the number of enabled cores in each processor. This option is set to All
per Processor by default.
Processor 64-bit Specifies if the processor(s) support 64-bit extensions.
Support
Processor Core Specifies the maximum core frequency of the processor.
Speed
Processor 1
The following settings are displayed for each processor installed in the system:
Option
Family-Model-
Stepping
Brand
Level 2 Cache
Level 3 Cache
Number of Cores
Related Links
Processor Settings
Viewing Processor Settings
SATA Settings
You can use the SATA Settings screen to view the SATA settings of SATA devices and enable RAID on
your system.
Related Links
SATA Settings details
System BIOS
Viewing SATA Settings
Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish
booting, and then restart your system and try again.
42
NOTE: Depending on the number of installed CPUs, there may be up to four
processor listings.
NOTE: Depending on the number of CPUs, there may be up to four
processors listed.
Description
Specifies the family, model, and stepping of the processor
as defined by Intel.
Specifies the brand name.
Specifies the total L2 cache.
Specifies the total L3 cache.
Specifies the number of cores per processor.