Figure 54. Removing a 2.5-inch (x4) SAS hard-drive or SSD backplane
1.
hard-drive or SSD backplane
3.
guide pin (5)
5.
connector
Next steps
1.
Install the hard-drive or SSD backplane.
2.
Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Installing a 2.5-inch (x4) SAS hard-drive or SSD backplane
Removing the blade
Removing the system cover
After working inside your system
2.
release latch (2)
4.
retention screw on the hard-drive or
SSD backplane cable connector
6.
hard-drive or SSD backplane cable
123