Dell PowerEdge M830 Owner's Manual page 120

1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #1 Phillips screwdriver ready.
4. Remove the hard-drive or SSD cage.
NOTE: alignment pin (2) You must remove the hard-drive or SSD cage to replace a faulty hard-
drive or SSD cage or service other components inside the system.
Steps
1. Align the screw holes on the hard-drive or SSD cage with the screw holes on the chassis.
2. Lower the hard-drive or SSD cage into the chassis until it is seated firmly in place.
3. Install the five screws to secure the hard-drive or SSD cage to the chassis.
Figure 53. Installing a hard-drive or SSD cage
1. hard-drive or SSD cage
3. guide pin (5)
5. standoff (2)
Next steps
1. Install the hard-drive or SSD backplane.
2. Install the hard drives or SSDs.
3. Follow the procedure listed in the After working inside your system section.
120
2. screw (5)
4. screw hole on the chassis (4)