Removing A 1.8 Inch Ssd From A 1.8 Inch Ssd Carrier - Dell PowerEdge M630 Owner's Manual

Steps
1. Slide the hard drive/SSD in to the hard-drive/SSD carrier.
2. Align the screw holes on the hard drive/SSD with the holes on the hard-drive/SSD carrier.
CAUTION: To avoid damaging the drive or the carrier, do not overtighten the screws.
3. Fasten the four screws to secure the hard drive/SSD to the hard-drive/SSD carrier.

Removing a 1.8 inch SSD from a 1.8 inch SSD carrier

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Ensure that you read the
Steps
Pull the rails on the side of the carrier and lift the SSD out of the carrier.
Figure 31. Removing and installing a 1.8 inch SSD in a 1.8 inch SSD carrier
1. SSD carrier
Next steps
Install a 1.8 inch SSD in a 1.8 inch SSD carrier. See
Safety instructions.
2. SSD
Installing a 1.8 inch SSD in a 1.8 inch SSD carrier.
79