Figure 61. Installing a 1.8-inch (x12) SAS SSD backplane
1.
SSD backplane
3.
guide pin (6)
5.
backplane cable connector that connects
to the connector on the system board
7.
connector on the expander card (EXP)
Next steps
1.
Install the SSDs in their original locations.
2.
Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing a 1.8-inch (x12) SAS SSD backplane
Installing the system cover
Installing a blade
After working inside your system
136
2.
release latch (2)
4.
backplane cable (2)
6.
connector on the system board
(SATA_BP)
8.
backplane cable connector that
connects to the connector on the
expander card