3.
Keep the 5 mm and 6 mm Hex nut drivers, #2 Phillips screwdriver, and #2 Phillips round screwdriver
ready.
4.
Remove the system board.
CAUTION: Do not lift the system board by holding a memory module, processor, or other
components.
CAUTION: Take care not to damage the system identification button while placing the system
board into the chassis.
NOTE: You must remove the system board to replace a faulty system board.
Steps
1.
Hold the system board by its edges and orient it toward the front of the chassis.
2.
Align the USB connectors with the slots on the front wall of the chassis.
3.
Lower the system board and install the screws to secure the system board to the chassis.
Figure 70. Installing the system board
1.
system board
Next steps
1.
Install the following:
151