Recommended Tools; Removing And Installing A Blade; Removing The Blade - Dell PowerEdge M830 Owner's Manual

Recommended tools

You need the following tools to perform the removal and installation procedures:
• Key to the bezel lock.
The key is needed only if your system includes a bezel.
• Phillips #1 screwdriver
• Phillips #2 screwdriver
• Torx #T8 and #T10 screwdrivers
• 5 mm and 6 mm Hex nut drivers
• Wrist grounding strap

Removing and installing a blade

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: These procedures are applicable only for full-height and half-height blades. For information
about removing and installing quarter-height blades from a sleeve, see the blade's Owner's Manual
at Dell.com/poweredgemanuals.

Removing the blade

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Power down the blade using OS commands or the CMC, and ensure that the blade's power is off.
When a blade is powered off, its front-panel power indicator is off.
4. Before removing the blades from full-height blade slots 3 or 4, rotate the LCD panel to the storage
position to prevent accidental damage to the LCD screen.
CAUTION: To protect the I/O connector pins, install the I/O connector cover any time a blade is
removed from the enclosure.
CAUTION: If you are permanently removing the blade, install a blade blank. Operating the system
for extended periods of time without a blade blank installed can cause the enclosure to overheat.
Steps
1. Press the release button on the handle.
2. Pull out the handle to unlock the blade from the enclosure.
56