Snmp Setting - GeoVision GV-VS04H User Manual

4.7.7 SNMP Setting

The Simple Network Management Protocol (SNMP) allows you to monitor t
camera through SNMP network management software. Note this function is
GV-VS04H (Firmware Version 1.05
or later) GV-VS14 and GV-VS2420 /2400.
1. Select Enable SNMPv1 SNMPv2c to enable the function.
2. To enable access to Read/Write Name, type a name strin
password to allow read and write access to the c
3. To enable Read only Name, type a name string to allow read-only acc
camera from the SNMP software.
4. For a more secured connection, select Enable SNMPv3
5. To enable access to SNMP
6. Select an Authentication Type to use for SNMP requests.
7. Type the Authentication Password and Current password (Encrypted). You will
need to type these passwords in the SNMP software to be able to access the camera.
8. To enable access to SNMPv3 Read only name, follow steps 5 to 7.
9. Click Apply to save the settings.
or later), GV-VS11, GV-VS12 (Firmware Version 1.05
Figure 4-37
v3 Read/write Name, type a name string.
Administrator Mode
4
g. This will serve as a
amera from the SNMP software.
to enable SNMP version 3.
he status of the
available for
ess to the
95