GeoVision GV-VS04H User Manual page 82

3. Port Number: Match the communication port on GV-Backup Center. Or keep the
default value 30000.
4. User Name: Type a valid user name to log into GV-Backup Center.
5. Backup Video:
Backup Center.
6. Compact Video: Select the cameras that you only want to back up their Key Frames
instead of full recordings, to GV-Backup Center. This option is usef
backup time.
7. Resend all files: Select this option in case of the netw
network is recovered, all the missing data will be resent to GV-Backup C
8. Password: Type a valid password to log into GV-Backup Center.
9. Enable Schedule Mode: Enable the GV-Backup Center connection on t
you set in the Select Schedule Time section. Refer to 4.5 Recording Schedule for the
same settings.
10. Click Apply. The Connection Status should display "Connected" and
If the GV-Backup Center has a failover server providing the uninterrupted b
in case of the GV-Bac
failover server.
1. Automatic Failover Support: Enable the automatic connection to t
once the connec
for the specified time.
2. Host Name or IP Address: Type the host name or IP
3. Port Numbe r: Match the communication port on the failover server. Or keep the
default value 30000.
4. User Name: Type a valid user name to log into the failover server.
5. Password: Type a valid password to lo
6. Click Apply.
Note: The Backup Video, Compact Video and Resend all files functions are available
for GV-VS04H (Firmware Version 1.03 or later), GV-VS11, GV-VS12 (Firmware Version
1.02 or later), GV-VS14 and GV-VS2420 / 2400.
74
Select the cameras that you want to back up their recordings to GV-
kup Center failure, you can also configure the connection to the
tion between GV-Video Server and GV-Backup Center is interrupted
ork interruption. After the
address of the failover center.
g into the failover server.
ul to save the
enter again.
he schedule
connected time.
ackup service
he failover server