Restoring To Factory Default Settings - GeoVision GV-VS04H User Manual

6.4 Restoring to Factory Default Settings

Among different models of GV-Video Server, the operation of restoring the GV-Video
Server to original default values can vary and the way the LEDs flash can also be different.
To restore to default settings, use the Reset and Load Default buttons on the front panel.
For the location of the two buttons see 1.7 Physical Description.
GV-VS04H and GV-VS14
1. Press and then release the Reset button immediately.
2. Press and hold the Load Default button until all 3 LEDs (Power, Ready and Disk
Full/Fault) are on. This may take up to 30 seconds.
3. Release the Load Default button. The process of loading default values is complete,
and the GV-Video Server starts rebooting itself with all 3 LEDs turning off.
4. Wait until the Power and Ready LEDs turn on again. After this all the settings are
returned to default values.
GV-VS11 and GV-VS12
1. Unplug and plug the power cable to start.
2. Press and hold the Default button until the Ready LED blinks. This may take up to 30
seconds. The Ready LED will blink twice.
3. Release the Default button. The process of loading default values is complete, and the
GV-Video Server starts rebooting itself with the 2 LEDs turning off.
4. Wait until the Power and Ready LEDs turn on again. After this all the settings are
returned to default values.
GV-VS2420 /2400
1. Press and then release the Reset button immediately.
2. Press and hold the Default button until the Ready LED blinks. This may take up to 30
seconds. The Ready LED will blink twice.
3. Release the Default button. The process of loading default values is complete, and
the GV-Video Server starts rebooting itself with the Ready LED turning off.
4. Wait until the Ready LED turns on again. After this all the settings are returned to
default values
Note: Before the Ready LED is on again, do not unplug the power cable; otherwise the
loading of default values will fail.
122