Output Setting - GeoVision GV-VS02 User Manual

Duration to set preset after input off x seconds: Specify the amount of time the
PTZ camera stays in "Input on" preset point before moving to "Input off" preset point.
Note: The input settings only function after you start Input monitoring manually or by
schedule. To configure the input monitoring, see 4.4 Monitoring.
For related PTZ settings, see 4.2.1 PTZ Settings.

Output Setting

The number of output devices the GV-Video Server can connect to vary from model to
model. GV-VS02 and GV-VS02A connect up 4 output devices; GV-VS12 connects 2 out
devices.
Select Enable to start the output device. Choose the output signal that mostly suits the
device you are using: N/O (Open Circuit), N/C (Grounded Circuit), N/O Toggle, N/C Toggle,
N/O Pulse and N/C Pulse. Set the pulse duration for the pulse mode.
Alarm Settings:
Note this option is only available for GV-VS02A and GV-VS12.
You can choose to automatically activate the configured output device for alarm under
these conditions: video lost, tampering alarm, disk write error and hard disk full.
Note: The Tampering Alarm option in the Alarm Settings field is only available for GV-
VS12.
Figure 4-11
Administrator Mode
4
41