Advanced Energy
• The display should be located approximately 160 cm (63") above the ground for
ease of use and operation. An elevated mounting position is permitted if easy
access to the display is provided. Viewing the display using a ladder, an aerial
platform or the equivalent is acceptable.
• Minimum clearances for each inverter must be observed.
• If the inverter contains the optional ADU, ensure that the alarm signal can be
easily heard and allows for proper follow-up.
☞
Important
Do not impair or block the heat sink cooling fins. Never install the units above
one another. Do not cover the cooling fins of the heat sink as this might cause
overheating of the inverter and may void the warranty.
Figure 4‑2. Inverter cooling fins
MOUNTING THE UNIT
The wall mount bracket included with the inverter can be used for installation on a
concrete wall or a metal framework. Before mounting the inverter, ensure that the
wall can handle the weight of the inverter(s).
4‑6
Heatsink cooling fins
Installing
570-1003552-05A