Figure 4-3. Wall Mounting And Bracket - Advanced Energy AE 3TL 600 Series Installation And Operation Manual

Advanced Energy
• Phillips screws
• Tool for installing anchor bolts if mounting on a wall
To Mount the Inverter
1. Hold the wall mount bracket against the wall or framework where the inverter
will be mounted.
2. Use a pencil to draw a level, horizontal line approximately 40 cm (16") above
the position intended for the display.
The inverter is designed only for vertical installation.
The following illustration shows the required dimensions and drilling locations
to attach the wall mount bracket to the wall.
M5 SS locking nut
Figure 4‑3. Wall mounting and bracket
3. Hold the wall mount bracket with the end with mounting hooks to the pencil
line. Verify that the wall mount bracket is level.
4. With the wall mount bracket in place, mark the screw holes with a pencil.
5. Remove the wall mount bracket.
6. Drill pilot holes.
7. Attach the wall mount bracket using the provided washers and screws.
Refer to
appropriate fasteners.
4‑8
Table 4-1 for specific information on wall structures and the
Installing
Wall
See the following table for anchors
See the following table for anchors
M5 x 20 SS screw
570-1003552-05A