Mitsubishi Electric GOT2000 Series Connection Manual page 70

(4) Formats 11 to 13 (Digital Electronics Corporation's memory link method)
This is the same format as the protocol of the Digital Electronics Corporation's memory link method.
Type
Digital Electronics Corporation's memory link
Format 11 method
(compatible mode)
Digital Electronics Corporation's memory link
Format 12 method
(extended mode, ASCII code 1:1)
Digital Electronics Corporation's memory link
Format 13 method
(extended mode, ASCII code 1:n)
(5) Formats 14, 15 (GOT-F900 Series microcomputer connection)
This is the same message format as when a microcomputer connection is established with the GOT-F900
Series.
Type
GOT-F900 Series microcomputer connection
Format 14
(format 1)
GOT-F900 Series microcomputer connection
Format 15
(format 2)

How to set data format
Set the data format at [Detail setting] in GT Designer3.
For details of the data format setting method, refer to the following.
2 - 20
2. MICROCOMPUTER CONNECTION (SERIAL)
2.5 Message Formats
Name
This is the basic format of the Digital Electronics Corporation's memory link
method.
This is the appended format of the Digital Electronics Corporation's memory
link method (compatible mode) with sum check, CR and LF.
This is the appended format of the Digital Electronics Corporation's memory
link method (extended mode, ASCII code 1:1) with a station No.
Name
Use this format when establishing a 1:1 or m:n connection between the
GOT and the host.
The end code is CR.
Use this format when establishing a 1:1 or m:n connection between the
GOT and the host.
The end code is ETX or sum check.
2.6.1 Setting communication interface (Communication settings)
Description
Description
Refer to
2.5.6
Refer to
2.5.7