Vnc(R) Server Function Setting - Mitsubishi Electric GOT2000 Series Connection Manual

HINT HINT HINT
System configuration between the GOT and PLC
For the system configuration between the GOT and PLC, refer to each chapter.
10.3 GOT Side Settings

10.3.1 VNC(R) server function setting

2.
1.
Select [Common] [Peripheral Setting]
Server] from the menu.
2.
Check the [VNC Server] of [Use VNC Server] to set.
For details on the settings, refer to the following
manual.
GT Designer3 (GOT2000) Help
3.
Click the [OK] button when settings are completed.
Mitsubishi Products
Non-Mitsubishi Products 1, Non-Mitsubishi Products 2
Microcomputer, MODBUS Products, Peripherals
Click!
[VNC
10.3.2 Setting communication
interface (Communication
settings)
®
For using the VNC server, Ethernet
communication drivers must be set on the GOT,
and set the Communication settings
2.
1.
Select [Common] [Controller Setting] from the
menu.
2.
The Controller Setting window is displayed. Select the
channel to be used from the list menu.
3.
Set Manufacturer, Controller Type, I/F, and Driver
according to the connected equipment to be used.
4.
The detailed setting is displayed after Manufacturer,
Controller Type, I/F, and Driver are set.
Make the settings according to the usage
environment.
Click the [OK] button when settings are completed.
10. VNC(R) SERVER CONNECTION
10.3 GOT Side Settings
3.
4.
10
Click!
10 - 3