Mitsubishi Electric GOT2000 Series Connection Manual page 295

12.3.2 Communication detail settings
Make the settings according to the usage environment.
Item Description
Set this item when change the
Transmission transmission speed used for
Speed communication with printer.
(Default: 19200bps)
Set this item when change the
data length used for
*1
Data Bit
communication with printer.
(Default: 8bits)
Specify the stop bit length for
Stop Bit communications.
(Default: 1bit)
Specify whether or not to
perform a parity check, and how
Parity it is performed during
communication.
(Default: None)
Set the number of retries to be
performed when a
Retry
communication error occurs.
(Default: 0times)
Set the time period for a
Timeout Time communication to time out.
(Default: 30sec)
Set this item to adjust the
transmission timing of the
Delay Time communication request from the
GOT.
(Default: 0ms)
Set this item when selecting the
XON/XOFF control for the
Control Method
control method.
(Default: XON/XOFF)
*1 When using the hard copy function, set to 8bit.
POINT POINT POINT
(1) Communication interface setting by the Utility
(2) Precedence in communication settings
Range
4800bps,
9600bps,
19200bps,
38400bps,
57600bps,
115200bps
7bits/8bits
1bit/2bits
None
Even
Odd
0 to 5times
3 to 90sec
0 to 300ms
XON/XOFF
None
The communication interface setting can be
changed on the Utility's [Communication setting]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following
manual.
GOT2000 Series User's Manual (Utility)
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
12. PRINTER CONNECTION
12.3 GOT Side Settings
12
12 - 5