Mitsubishi Electric GOT2000 Series Connection Manual page 178

(3) In the case of interrupt outputs
The following shows an example of an interrupt output when data are written to the interrupt output devices
(D13).
(Assuming that "31
Item
When [Interrupt Data Byte] in "Communication Detail Settings" is set to "1 byte"
Interrupt output
(GOT host)
POINT POINT POINT
Interrupt output
• To disable the interrupt output, turn ON SM52 (interrupt code output disable flag).
( 3.3.6 SM devices)
• To enable the interrupt output, set 8 bits to the data length at "Communication Detail Settings".
( 3.5.1 Setting communication interface (Communication settings))
• When "7 bits" is set, the MSB (8th bit) is ignored. (Example: FF
3 - 48
3. MICROCOMPUTER CONNECTION (ETHERNET)
3.4 Message Formats
" is written to D13.)
H
Example: When the number of interrupt data bytes is 1
D13 31
H
Interrupt
Interrupt output
Output
value 1
31
H
Message format
Output
value 1
31
H
7F )
H H