Table of Contents
Advertisement
C
ONFIGURE
To change the factory default settings, remove the small rectangular access panel located in the upper center of the face
of the clock/timer. To aid in removal, there is a small recess in the top center of this panel. The panel can be removed with
a small screwdriver by gently prying the center top edge of the access panel forward. Setting changes can be made while
the clock/timer is ON and changes will take effect within a few seconds.
NOTE: When power is first applied to the clock or the reset button is pushed, a decimal point will flash for
approximately three minutes while the clock/timer receiver is turned on to capture the transmitter signal. If
the clock/timer does not receive valid time data from the transmitter for 72 hours, the red colon on the clock
will flash.
Set LED Dimmer Display - XR Classic Series
NOTE: The LED Display is set to 100% by factory default.
To dim the LEDs by 25% for a 2.5" display set Dimmer 2 in the up position and for a 4" display set Dimmer 8 in the up
position, as illustrated below.
Figure 2: Dimmer 25%
To dim the LEDs by 50% for a 2.5" display set Dimmer 1 in the up position and for a 4" display set Dimmer 7 in the up
position, as illustrated below.
Figure 3: Dimmer 50%
To dim the LEDs by 75% for a 2.5" display set Dimmer 1 and 2 in the up position and for a 4" display set Dimmer 7 and 8 in
the up position, as illustrated below.
Figure 4: Dimmer 75%
Primex Wireless
D
C
IGITAL
LOCK AND
XR Classic Series Digital Clock/Timers Installation Guide
T
S
- C
IMER
ETTINGS
S
LASSIC
ERIES
10
Advertisement
Table of Contents
