Primex XR Classic Series Installation Manual page 29

Code Blue Timer Input: wire to designated code blue system and timer control switch.
l
Elapsed Timer Input: wire to timer control switch. see "Timer Control Switch Installation" on page 30.
11. Place the clock assembly into the wall opening. The clock assembly is to be flush on the wall and the junction box
holes must line up with the clock assembly slots.
Figure 29: Flush Mounting
Figure 30: Clock Assembly Slots
NOTE: If the clock assembly does not line up with the junction box it is possible to increase the opening up to 0.3"
(14.7" total) on either side as well as 0.2" (5.6" total) on the top or bottom. If these adjustments still do not
allow the clock assembly to be mounted to the junction box correctly, it is required to remount the junction
box.
12. Install drywall anchors (not supplied) to align with the four fastening holes located on the front of the clock
assembly.
13. Mount the clock assembly to the junction box(es), using the screws supplied with the junction box and the #8
washers (supplied).
Primex Wireless
XR Classic Series Digital Clock/Timers Installation Guide
29