Table of Contents
Advertisement
Surface-mount Wall Bracket Installation
Complete the instructions illustrated below to mount a digital clock/timer using the supplied tilt mount bracket.
You may mount the tilt bracket directly to the wall with the four #10 screws and anchors (supplied). To
l
determine the spacing of the screws, see "Surface-mount Tilt Bracket Mounting Dimensions" on page 19.
Hard-wired installation requires a 120V~ power line in a junction box installed by a licensed electrician. The tilt
l
bracket has a center pass-through hole for the 120V~ pigtail. If a junction box is present, the tilt bracket also has
mounting holes spaced to allow direct attachment of the tilt bracket to the cover plate screw holes on the
junction box.
Figure 12: Tilt Bracket Mount
Primex Wireless
XR Classic Series Digital Clock/Timers Installation Guide
16
Advertisement
Table of Contents
