Set State - Timer Mode - Primex XR Classic Series Installation Manual

Table 6: Normal State Operation Specifications
Pressing the button...
DISPLAY
EXIT
STOP/START
INCREMENT
RESET
SET/CHANGE

Set State - Timer Mode

The Set State is used to set the count-up start time and the count-down start time. Enter Set State by holding the RESET
button while in count-up or count-down mode.
In this state:
The text labeled on the bottom of the switch control button is applicable (SET/CHANGE, INCREMENT, EXIT).
l
The dash, colon, and decimal points are not displayed.
l
The digit that is currently being set will flash.
l
Primex Wireless
Clock Mode
Pressing DISPLAY scrolls through the various modes in the following order:
1.
Clock Mode
2.
Count-Up Mode
3.
Count-Down Mode
Ignored
Ignored
XR Classic Series Digital Clock/Timers Installation Guide
Count-Up Mode
Controls the up counter
while in count-up mode.
If the counter is stopped,
pressing the STOP/START
button starts the counter.
If the counter is started,
pressing the STOP/START
button stops the counter.
Pressing the RESET button
once automatically stops and
resets the up counter to its
preset time (pause).
Or
Holding the RESET button
puts the time into SET
STATE.
Count-down Mode
Controls the down counter
while in count-down mode.
If the counter is stopped,
pressing the STOP/START
button starts the counter.
If the counter is started,
pressing the STOP/START
button stops the counter.
Pressing the RESET button
once automatically stops and
resets the down counter to
its preset time (pause).
Or
Holding the RESET button
puts the time into SET
STATE.
33