MIMAKI UJF-3042 Maintenance Manual page 9

Maintenance Manual > Operating Principle > Basic Operation > Sequence at POWER OFF
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver
1.1.2 Sequence at POWER OFF
 Sequence at turning OFF the power supply
The flow until the power supply is turned OFF is as below:
No. Item
1 UV Power OFF
2 Moving to local
3 Saving parameter
4 Moving head to capping
position
5 Turn Power of SLIDER PCB
OFF
6 Saving event log
7 Power OFF
© 2011 MIMAKI ENGINEERING CO.,LTD.
Turns OFF the power supply of the UV lamp unit.
If the status is other than local, changes it to local.
Saves the parameters below when the power supply is turned OFF.
• Saving the parameter value
• Backup of the parameter to F-ROM
In addition, performs check sum and displays ERROR817 (save area error) when an error occurs.
Moves the head to the capping position if it stays away from that position.
* Depending on the mode, it may not return to the capping position.
Saves turning OFF the power supply to the event log.
1.80 / 1.00 Remark
Process content
Rev.
2.0
1
2
3
4
5
6
7
8
1.1.2 R.2.0 P.1