2011 Mimaki Engineering Co.,Ltd - MIMAKI UJF-3042 Maintenance Manual

Maintenance Manual > Adjustment > Adjustment Items > HEAD ADJUST
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver
4.2.2 HEAD ADJUST
 Head Back/Forth Adjustment Adjusting Procedure
Back/forth fixing
screw
© 2011 MIMAKI ENGINEERING CO.,LTD.
1. Loosen the back/forth fixing screw of the target head.
2. Rotate the back/front adjustment screw according to the amount
of displacement to adjust the back and forth positions.
Rough indication of turning angle: About 5 µm by one-eighth
rotation
Direction of turning the micro adjuster
Head back/forth
adjustment screw
Dot position down: Turn clockwise (CW).
Dot position up: Turn counterclockwise (CCW).
3. Tighten the loosened back/forth fixing screw.
4. Draw the pattern again and check if no displacement occurs.
1.80 / 1.00 Remark
Tighten the screws with care that the head is not
shifted from the correct position.
Repeat "Adjusting" -> "Patterns Drawing" until no
more displacement is available.
Rev.
2.0
1
2
3
4
5
6
7
8
4.2.2 R.2.0 P.8