MIMAKI UJF-3042 Maintenance Manual page 206

Maintenance Manual > Troubleshooting > Details on Errors and Malfunctions > List of Error Messages
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver
7.1.2 List of Error Messages
 List of Error Messages (5/9)
No. LCD
ERROR 511
Z ORIGIN
38
ERROR 601
INK NEAREND
39
ERROR 602
INK END
40
ERROR 603
NO CARTRDG
41
© 2013 MIMAKI ENGINEERING CO.,LTD.
Cause
Z-origin error
(Origin of Z-axis can not be detected)
Ink near end (A small amount of ink left) (When the message is still displayed even after a new Ink
Ink end (No ink left)
No cartridge (Cartridge is not installed)
1.80 / 1.00 Remark
List of Countermeasures
1. Execute and confirm [#TEST]->[SENSOR TEST]->
[TBL-ORG].
2. Check the connection of connector of the Z-origin
Sensor.
3. Replace the Z-origin Sensor with a new one.
4. Disconnect and connect the connector of the Z-
Motor(Stepping motor).
5. Replace the Station III PCB with a new one.
(Refer to 6.4.4)
Cartridge or an empty Ink Cartridge is charged;)
1. Execute and confirm [#TEST]->[SENSOR TEST]->
[INK NEND1](The number meets the cartridge No.).
2. Check the peripheral and the assembly of the End
Sensor.
3. Check the connection of the Presence Sensor and the
Near End Sensor.
4. Replace the Cartridge with a new one
5. Replace the Presence/Near End Sensor with a new
one.
6. Replace the SL-Relay PCB with a new one.
(Refer to 3.3.2)
7. Replace the Main PCB with a new one.
(If this message appears when a new cartridge or a
cartridge with enough ink is set)
1. Execute and confirm [#TEST]->[SENSOR TEST]->
[INK NEND1](The number meets the cartridge
2. Check the peripheral and the assembly of the End
Sensor.
3. Check the connection of the Presence Sensor and the
End Sensor.
4. Replace the Cartridge with a new one.
5. Replace the Presence / Near End Sensor with a new
one.
6. Replace the SL-Relay PCB with a new one.
(Refer to 3.3.2)
7. Replace the Main PCB with a new one.
(When the message is still displayed even after a Ink
Cartridge is charged;)
1. Execute and confirm [#TEST]->[SENSOR TEST]->
[INK1](The number meets the cartridge No.)..
2. Check the peripheral and the assembly of the Presence
Sensor.
3. Check the connection of the Presence Sensor and the
End Sensor
4. .Replace the Cartridge with a new one
5. Replace the Presence/Near End Sensor with a new
one.
6. Replace the SL-Relay PCB with a new one.
(Refer to 3.3.2)
7. Replace the Main PCB with a new one.
Rev.
2.0
1
2
3
(Refer to 3.3.1)
4
No.).
5
(Refer to 3.3.1)
6
7
(Refer to 3.3.1)
8
7.1.2 R.2.0 P.5