Maintenance Manual > Disassembly and Reassembly > PCBs > Main PCB
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver
6.4.2 Main PCB
Procedures
A button type lithium battery is used for this board. Warn following 1)~4).
1), Danger of explosion if battery is incorrectly replaced.
2), Replace only with the same or equivalent type recommended by the manufacture.
Recommended type : [CR2032]
3), Dispose of used batteries according to the manufacturer
4),When the battery is replaced with a new one, pay attention to the polarity at replacing.
To turn power off, be sure to turn the main power OFF.
Remove the Power Plug. Adjacent parts can be at high voltage and it may cause electrical shock.
Be sure to start the work after confirming the working process.
(Refer to
"3.3.1 Replacement of Main
© 2011 MIMAKI ENGINEERING CO.,LTD.
PCB")
1. Turn the main power OFF.
2. Remove the Power Plug.
3. Disconnect all connectors on PCB.
4. Remove the Main PCB Assy.
Screws : P3x8SMW x6
Main PCB Assy.
5. Reverse the disassembly procedure for reassembly.
---
Remark
s instructions.
'
When a used Main PCB is to be discarded, remove
the installed battery (CR2032).
Disposal of the used battery according to manufac-
turer's instructions
Rev.
2.0
1
2
3
4
5
6
7
8
6.4.2
R.2.0
P.1