Maintenance Manual > Disassembly and Reassembly > Driving Parts > Z-Driving Screw
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver
6.3.4 Z-Driving Screw
Procedures
To turn power off, be sure to turn the main power OFF.
Be sure to start the work after confirming the working process.
(Refer to
"3.2.1 Replacement of Z-Driving
Front Cover-Under TB
Z-Motor-Reinforce Plate
Z-Driving Screw
E Ring
© 2011 MIMAKI ENGINEERING CO.,LTD.
1. Remove the following covers:
• Front Cover-Under TB
• Z-Motor-Reinforce Plate
Front-Cover-TB
2. Remove the E Ring attached to the far side of the Z-Driving
Screw.
---
Remark
Screw")
(The Front Cover-TB can be kept attached.)
Notes for removing E Ring.
1. Remove two screws that fix the Z-Driving
Base.
2. Pull the Z-Driving Base.
By this, gap is created between the E Ring and Bear-
ing, and this will allow you to remove the E Ring
easily.
Z-Driviing Base
Pull toward you
Rev.
2.0
1
2
3
4
5
6
E Ring & Bearing
7
8
6.3.4
R.2.0
P.1