2011 Mimaki Engineering Co.,Ltd - MIMAKI UJF-3042 Maintenance Manual

Maintenance Manual > Adjustment > Adjustment Items > ORIGIN ADJUST
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver
4.2.11 ORIGIN ADJUST
Origin Seal
 Outline
The pattern is drawn and the origin position (the drawing reference point located at the front right) is parameter-com-
pensated.
 Work Procedures
FUNCTION
#ADJUST <ent>
#ADJUST
ORIGIN ADJUST <ent>
#ORIGN ADJUST
CLEAR < > DRAW
#ORIGN ADJUST
PRINTING
#ORIGN ADJUST
X=***.* Y=***.*
Pattern
Origin
Form
© 2011 MIMAKI ENGINEERING CO.,LTD.
1.80 / 1.00 Remark
1. Display [#ADJUST] -> [ORIGIN ADJUST].
2. Press the [] key to draw the pattern.
[]: To execute Pattern drawing
[]: To initialize Adjustment value
3. Compensate it so that the corner part of pattern and the inside
corner part of Origin Seal align on the same line.
Specified value: X=22.0 Y=32.0
[],[]: To move Cursor.
[],[]: To change Compensating value
(unit: 0.1 mm)
[ENTER]: To register Compensating value
4. After compensated, draw the pattern again, and then check the
displacement and compensate it if necessary.
Rev.
2.0
1
25
2
32
3
4
5
6
7
8
4.2.11 R.2.0 P.1