Sanyo MCO-19M Service Manual page 61

14. Hardware status
Set temperature A value displayed in the "SV" row in the right side of "Temp" column
Current chamber temperature: A value displayed in the "PV" row in the right side of "Temp" column
PWM output for heater: A value displayed in the "PWM" row in the right side of "Temp" column
Set CO2 density: A value displayed in the "SV" row in the right side of "CO2" column
Current CO2 density: A value displayed in the "PV" row in the right side of "CO2" column
PWM output for CO2 valve: A value displayed in the "PWM" row in the right side of "CO2" column
Set O2 density: A value displayed in the "SV" row in the right side of "O2" column
Current O2 density: A value displayed in the "PV" row in the right side of "O2" column
PWM output for N2/O2 value: A value displayed in the "PWM" row in the right side of "O2" column
Set temperature in CO2 sensor box: A value displayed in the "SV" row in the right side of "CO2 SBOX" column
Current temperature in CO2 sensor box: A value displayed in the "PV" row in the right side of "CO2 SBOX" column
PWM output for sensor box heater: A value displayed in the "PWM" row in the right side of "CO2 SBOX" column
Current temperature in AT sensor * : A value displayed under the "AT" row
Set temperature in overheat protection sensor: A value displayed under the "LIMIT" row
Note) AT sensor is located on the PCB inside the rear cover, so temperature sensed by AT sensor will be higher than an
actual ambient temperature.
Note) In "Hardware Status" display, Auto Return furnction is inactive.
(A device does not return to Top Screen automatically)
- 58 -