Sanyo MCO-19M Service Manual page 50

<Setting of O2 density for standard gas calibration>
Step for standard gas calibration mode
Current step in standard gas calibration is displayed.
Status of unit
Status of unit in standard gas calibration is displayed.
Error message
Error message is displayed.
Message for operator
When standard gas calibration mode is complete, the message is shown for an operator.
Density in CO2 sensor during standard gas calibration
CO2 density sensed by CO2 sensor during standard gas calibration is displayed.
Setting density of CO2 standard gas
CO2 density in standard gas cylinder is displayed.
Density in O2 sensor during standard gas calibration
O2 density sensed by O2 sensor during standard gas calibration is displayed.
Setting density of O2 standard gas
O2 density in standard gas cylinder is displayed.
- 47 -