Sanyo MCO-19M Service Manual page 184

SPECIFICATIONS
Name
Models
External dimensions
Internal dimensions
Interior volume
Exterior
Interior
Outer door
Inner door
Gastight split door
Trays
Access port
Insulation
Heating system
Heater
Humidifying system
Temperature controller
Temperature display
CO controller
2
CO density display
2
O controller
2
O density display
2
Air circulation
Air filter
UV lamp
Water level sensor
Alarms
Remote alarm contacts
CO inlet connection
2
CO inlet pressure
2
O inlet connection
2
O inlet pressure
2
Weight
MCO-19M
W620 x D710 x H900 mm (W24.4 x D28.0 x H35.4 inch)
W490 x D523 x H665 mm (W19.3 x D20.6 x H26.2 inch)
Stainless steel containing copper
4 doors made of tempered glass
3 trays made of stainless steel containing copper
W450 x D450 x H12 mm (W17.7 x D17.7 x H0.47 inch), Maximum load: 7 kg/tray
Inner diameter: 30 mm (1.18 inch), On the back side
Rigid polyurethane foamed-in place
DHA system (heater jacket + air jacket system)
Natural evaporation with humidifying pan
0.3 m, Efficiency: 99.97% or higher
-----
Automatic set temperature alarm, Automatic set CO2 density alarm
Automatic set O2 density alarm, Upper limit temperature alarm
various gas/sensor/heater alarms
Allowable contact capacity: 30 VDC, 2 A
4 to 6 mm (0.157 to 0.236 inch) diameter tube can be connected
0.03 MPaG (0.3 kgf/cm
4 to 6 mm diameter tube can be connected
0.05 MPaG (0.5 kgf/cm
- 181 -
Multi-gas Incubator
MCO-19M(UV)
162 L (5.72 cu.ft.)
Painted steel
Painted steel
Stainless steel with gasket
314 W
PID control system
Digital display
PID control system
Digital display
PID control system
Digital display
Fan assisted
4W X 1 (ozone-free emission)
Optical
2
G, 4.3 psiG)
2
G, 7.1 psiG)
94 kg
MCO-19M(UVH)
74