Basic Operations On Control Panel - Sanyo MCO-19M Service Manual

BASIC OPERATIONS ON CONTROL PANEL

The following operation are possible through control panel:
Setting the temperature・・・The chamber temperature can be set (page 25).
Setting the CO
2
Setting the O density・・・The chamber O
2
Setting the key lock・・・Changing the temperature and CO
Setting alarms・・・The temperature alarm, CO
limit alarm temperature (page 32) can be set.
Setting UV parameters・・・ON/OFF parameters and the ON period of the UV lamp can be set for the
MCO-19M(UVH)/19M(UV) or when the Incubator is equipped with the optional MCO-19UVS (page 36).
Setting other parameters・・・The initial settings of the date, time, and log cycle (page 38), and the
LCD display and baud rate (page 40) can be set.
Displaying the operation log and transferring data・・・A graph of past operation data can be
displayed (page 41) and operation data can be transferred to a PC (page 43).
H O decontamination・・・H
2 2
performed when the optional H
Automatic N (or O
2
30). The CO gas cylinder can be switched when the optional automatic CO
2
System (MCO-21GC) is installed (page 67).
Setting the standard gas density・・・The standard gas density can be set when the optional
Automatic Standard Gas Calibration Kit (MCO-SG) is installed. (page 69)
density・・・The chamber CO
O decontamination of the chamber and internal attachments can be
2 2
O Generator (MCO-HP) is installed (page 49).
2 2
) gas cylinder changeover・・・The N
2
density can be set (page 25).
2
density can be set (page 25).
2
density can be disabled (page 26).
2
density alarm, O density alarm (page 33) and upper
2 2
(or O ) gas cylinder can be switched (page
2 2
- 131 -
Cylinder Changeover
2
24