Installation involves all of the above steps
–
in reverse sequence.
Dipped/main beam headlights and
side light
Single headlight.
Fig. 94
Fig. 95
Dipped beam/main beam and side
light of the single headlight.
Fuses and bulbs
Remove the cover
Raise the bonnet.
–
›››
Move the loop
Fig. 94
in the direction
–
1
of the arrow and remove the cover.
Changing the dipped/main beam headlight
›››
Remove connector
Fig. 95
–
bulb.
›››
Unclip the retainer spring
Fig. 95
–
pressing inwards to the right.
Extract the bulb and fit the replacement so
–
that the lug on the base fits into the recess
on the reflector.
Fit the connector.
–
Fit the cover and close the strap. Make sure
–
that the gasket sits well on the casing cover
during the operation.
Check whether the new bulb is working.
–
Changing the side light
›››
Fig. 95
Extract the bulb holder
–
wards.
Remove the bulb by pulling it out and fit-
–
ting the new one.
Installation involves all of the above steps
–
in reverse sequence.
Fit the cover and close the strap. Make sure
–
that the gasket sits well on the casing cover
during the operation.
Check whether the new bulb is working.
–
Double headlight bulb change
Position of the bulbs
from the
3
2
Double headlight.
Fig. 96
Side lights
A
Main beam headlights
B
Dipped beam headlights
C
Turn signal
out-
D
4
DRL (LED day light)
E
85